Xerox Versant 80 Press - Paper Jam Procedures for the Finisher Module; Paper Jams in the Finisher Module

Recommended SolutionPossible CauseFault Code
1. Refer to the DFA device user
documentation and follow in-
structions on how to clear the
fault.
2. Set or change the profile value
(refer to the DFA user document-
ation).
3. Power Off / On the press and re-
send / rescan the job.
4. If the fault persists, contact the
Customer Support Center.
Paper jam in the DFA device051-913, 051-914,
051-915
Paper Jam Procedures for the Finisher Module
Paper Jams in the Finisher Module
For detailed instructions on clearing paper jams in the Finisher Module, refer to the
following procedures:
• Paper Jams in the Post-Process Inserter (Tray 8 / T1)
• Paper Jams at Finisher Top Tray
• Paper Jams at Finisher Stacker Tray
• For paper jams inside the Finisher Left Cover, refer to the following procedures:
- Paper Jams at Lever 1a and Knob 1c
- Paper Jams at Lever 1d
- Paper Jams at Lever 1b
• For paper jams inside the Finisher Right Cover, refer to the following procedures:
- Paper Jams at Lever 3b and 3d
- Paper Jams at Lever 3e and Knob 3c
- Paper Jams at Lever 3g and Knob 3f
- Paper Jams at Lever 4b and Knob 3a
• For paper jams at the optional C / Z Folder, refer to the following procedures:
- Paper Jams at Lever 2a and Knob 3a
- Paper Jams at Lever 2b and Knob 2c
- Paper Jams at 2c, 2e, 2f, and 2d
- Paper Jams in Areas 4b and 4c
• For Standard Stapler jams and faults, refer to the following procedures:
- Stapler Faults Overview
26-7Xerox
®
Versant
®
80 Press
User Guide
Standard Finisher Plus