Xerox Versant 80 Press User Manual

Finisher Problem Solving
Problem Solving Information
Tip
Always ensure that all paper jams, including any small ripped pieces of paper, are cleared
before proceeding with your print jobs.
Note
Remedies differ according to the paper jam location. Follow the instructions displayed
to remove the jammed paper.
Fault Codes - Standard Finisher / Booklet Maker Finisher
If an error caused the printing to end abnormally, or a malfunction occurred in either
the Standard Finisher or the Booklet Maker Finisher, then an error code is displayed.
If an error persists after following the listed solution, then contact your Xerox Customer
Support Center.
Recommended solutionPossible causeFault code
Check for any paper jams in the paper
path and remove all sheets.
Paper Jam along booklet
and/or folder paths
012-100 to 012-104,
012-108 to 012-115,
012-117 to 012-120
Check for any paper jams in the paper
path and remove all sheets. Power Off/On
the press and, if needed, resend the print
job. If fault persists, call for service.
The finisher malfunctioned012-125, 012-132,
012-211 to 012-265,
012-282 to 012-296
Make sure the module door is fully closed.
Power Off / On the press if fault persists.
Interlock Fail012-302
Remove and replace the staple waste
container in the finisher.
Staple Waste Container near
full
012-400
Check that the Punch Waste Container is
installed in the finisher and inserted cor-
rectly.
Punch Waste Container is not
attached
012-949
Remove the Staple Waste Container and
install a new one.
The Staple Waste Container
is full or near full
024-931
Check that the Staple Waste Container
is installed in the finisher and inserted
correctly.
The Staple Waste Container
is not attached
024-932
24-11Xerox
®
Versant
®
80 Press
User Guide
Standard Finisher / Booklet Maker Finisher

Xerox Versant 80 Press Specifications

General

Brand	Xerox
Model	Versant 80 Press
Category	Printer
Language	English