Recommended solutionPossible causeFault code
Check the staple cartridge and reset cor-
rectly. If needed, replace with a new
cartridge. Resume job.
The booklet staple cartridge
is empty or stapling error oc-
curred
024-943
Add paper to the paper tray.Post-Process Inserter Tray is
empty or out of paper
024-957
Reset/change the paper or cancel the job.When feeding paper from the
Post-Process Inserter Tray, the
designated paper size and the
actual size of paper in the
tray differ.
024-974
Check staples and reset correctly.Finisher staple fault024-976
Check staples and reset correctly.Finisher staple feeding is not
ready
024-977
Check staples and reset correctly.Booklet Maker Finisher staple
operation is not ready
024-978, 024-989
Check staples. Remove and replace the
staple cartridge.
The staple cartridge is empty024-979
Remove all paper from the stacker tray.The stacker tay is full024-980
Remove all paper from the Finisher top
tray.
The top tray is full024-981
Remove all paper from the stacker tray
and remove any other obstructions.
The Finisher stacker tray
lower safety warning is on
024-982
Remove all paper from the Booklet tray.The Finisher Booklet tray is
full
024-983
Remove all paper from the Booklet tray.The Booklet stapler low staple
signal is on
024-984, 024-985
Remove all paper fromthe tray. Set the
output tray for three-fold. Check that the
folder tray is correctly attached and set.
The Booklet folder tray is full024-987, 024-988
Power Off/On the press. Resend the print
job if needed. If fault persists, contact
Customer Support Center.
A communication error has
occurred with the Finisher
047-320
Remove and empty the waste container
and then reinstall it completely.
The Punch Waste Container
is full or near full
112-700
Xerox
®
Versant
®
80 Press24-12
User Guide
Standard Finisher / Booklet Maker Finisher