Xerox Versant 80 Press - Advancedpunch Pro Problem Solving; Fault Codes - GBC Advancedpunch Pro

2. Apply oil lightly along the length of the pad, but do not over saturate.
3. To oil the die set, apply a small bead of oil along the entire length of the felt strip
that is located on the die set.
Note
Do not use spray lubricants because they dry up quickly and leave a sticky residue.
4. Wipe clean, leaving a light coat of oil on them.
Oil from the die set may blemish the first few punched sheets after oil has been
applied.
5. Run punched test prints until the punched output is clean and free of oil.
AdvancedPunch Pro Problem Solving
Fault Codes - GBC AdvancedPunch Pro
Fault codes for the GBC AdvancedPunch Pro are displayed on the press User Interface
/ Control Panel.
RemedyCauseFault Code
1. Open AdvancedPunch Pro front
door and look for a paper jam; refer
to Clearing Paper Jams in the Ad-
vancedPunch Pro.
2. Remove any paper jam.
3. Close front door.
Jam is detected in the Advanced-
Punch Pro.
040-100
040-101
040-900
040-901
Close front door of the AdvancedPunch Pro.Front door of the Advanced-
Punch Pro is not closed.
040-300
Install punch die set or fully insert it; close
front door.
The punch die set is missing or
not fully installed.
040-940
Install and / or fully insert punch container;
close front door.
Punch chip container is missing
or not fully installed.
040-941
22-23Xerox
®
Versant
®
80 Press
User Guide
GBC AdvancedPunch Pro