Skew Adjustment Levers (Trays 8 and 9)
The skew adjustment levers are found in all paper trays. These levers are used to improve
paper feed accuracy and to reduce paper skew problems.
1 Rear Skew Adjustment Lever
2 Right Side Skew Adjustment Lever
Note
These levers should remain in their default position. The position of these levers should
be changed only if there is a skew problem when running a specific print job and / or
media type. Changing the levers may cause more skew problems when running certain
media types such as coated, label, transparency and film.
Use the following procedure to set the skew adjustment levers:
1. Pull out the tray slowly until it stops.
The Stock Library Manager and Tray settings automatically display at the print server.
2. From the Tray Properties window at the print server, verify that the correct paper
information is being used including size, type, weight and paper curl or alignment
option for the tray. Select OK and close the Tray Properties window.
3. At the tray, slide the rear skew adjustment lever to the right.
4. Gently push in the tray until it comes to a stop.
5. Run your print job.
• The paper is fed accurately without skew and the printed output is satisfactory;
your task is complete.
• The paper is skewed and the printed output is unsatisfactory; proceed to the next
step.
6. Pull out the tray slowly until it stops.
7. Verify the tray and paper settings at the print server.
8. Return the rear skew adjustment lever to its left, default position.
9. Slide the right-side skew adjustment lever toward the front of the paper tray.
10. Gently push in the tray until it comes to a stop.
11. Run your print job.
• The paper is fed accurately without skew and the printed output is satisfactory;
your task is complete.
3-17Xerox
®
Versant
®
80 Press
User Guide
Paper and Media
To Next Page
Loading...
