Xerox Versant 80 Press - Page 52

3. Open the front cover of the OHCF.
4. Remove the Postcard Bracket from inside the OHCF front cover.
5. Install the Postcard Bracket so that it sits on the locating pins on the upper frame
and in the grooves on the bottom of the tray.
6. Tighten the thumb screw so it locks the Postcard Bracket in place.
7. Load the postcard stock and adjust the paper guides against the stock.
8. Close the paper tray and confirm the new settings at the print server.
9. Run your print job.
10. Upon completion of your print job, remove the postcard stock and the Postcard
Bracket from the tray.
11. Store the Postcard Bracket inside the OHCF front cover area.
Xerox
®
Versant
®
80 Press3-16
User Guide
Paper and Media