Xerox Versant 80 Press - Punch dies

DescriptionNameItem
The green LED illuminates when the power switch on
the AdvancedPunch is set to the on position.
Note
The power cord for the AdvancedPunch must be
plugged into the appropriate power source prior to
setting the power switch to the on position.
Power On1
When the punch container becomes full of waste paper
remnants,the yellow LED illuminates.
Empty Punch Container2
When the punch container is removed or not fully in-
serted into the punch unit, the yellow LED illuminates.
Fully Insert Punch Contain-
er
3
When the punch die is removed or not fully inserted
into the unit, this LED illuminates.
Fully Insert Punch Die4
When the front door is open or not completely closed,
the yellow LED illuminates.
Close Front Door5
When a sheet of paper becomes jammed within the
punch unit,the yellow LED illuminates. Remove the
sheet that is jammed within the AdvancedPunch.
Clear Paper Jam6
Note
The LED indicators on the AdvancedPunch will glow dimly if the press is turned on while
the AdvancedPunch power switch is in the Off position. After switching on the
AdvancedPunch, the LED indicators illuminate to their full intensity.
Punch Dies
The GBC AdvancedPunch is capable of punching a variety of hole-punch patterns by
simply changing the punch die. Punch dies can be changed in seconds without tools.
Two punch dies are shown in the following illustrations.
21-3Xerox
®
Versant
®
80 Press
User Guide
GBC AdvancedPunch