Xerox Versant 80 Press - OHCF Jam Clearance (Trays 6 and 7); Clearing OHCF Jams (Trays 6 and 7); Paper Jams When the Bypass Is Installed on Trays 6 and 7

Recommended SolutionPossible CauseFault CodeFault Area
1. Fan the paper to eliminate
paper adhesion (especially
in high humidity or high
temperature environments).
2. For 1-Tray OHCF (only):
Ensure that both Paper
Weight Switches are set
correctly; the switches are
located on paper tray.
3. Check the position of Skew
Adjustment Levers. The
levers should be retracted.;
refer to Skew Adjustment
Levers (Trays 6 and 7).
4. Replace the tray feed rolls
(feed, retard, nudger); refer
to Replacing the OHCF Feed
Rolls (Trays 6 and 7).
5. If problem still persists,
contact the Customer Sup-
port Center.
Repetitive misfeeds or
multifeeds
078-106,
078-125,
078-126,
078-127,
078-156
Trays 6 and 7
OHCF Jam Clearance (Trays 6 and 7)
Clearing OHCF Jams (Trays 6 and 7)
Nip Release levers inside of the Transport area of the Feeder hold back large size sheets
(such as A3, 11 x 17 inches, 12 x 18 inches) to reduce the chance of jamming as paper
enters the print engine.
Note
Follow the jam clearance instructions displayed on the touch screen. Always ensure that
all paper jams, including any small ripped pieces of paper, are cleared before proceeding
with your print jobs.
Paper Jams When the Bypass is Installed on Trays 6 and 7
Tip
Always ensure that all paper jams, including any small, ripped pieces of paper, are cleared
before proceeding with any print jobs.
1. Remove the paper currently loaded in the Bypass (Tray 5).
Xerox
®
Versant
®
80 Press17-8
User Guide
1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)