HCS Problem Solving
Fault Codes - High Capacity Stacker (HCS)
Note
The press configuration can be installed with one or two stacker modules. If the press
includes two HCS modules, the prefix 049 identifies a fault in the first module, and the
prefix 149 identifies a fault in the second module.
This fault code table lists problems and suggested solutions that apply to the High
Capacity Stacker (HCS).
Recommended SolutionPossible CauseFault Code
Carefully remove all sheets and paper
scraps from the jam clearance areas.
jammed paper049-100 - 049-121
Power Off / On the machine. If the
problem persists, contact the Customer
Support Center.
HCS sensor faults049-200 - 049-299
Power Off / On the machine. If the
problem persists, contact the Customer
Support Center.
HCS communication fault049-300
Check the properties of the tabs job and
resend the job.
Tabbed sheet fault049-700
Check the paper path of the module
and carefully remove all sheets from
the paper path areas.
Sheets remain in the paper
path
049-900 - 049-908
Open the HCS front door and remove
all sheets and paper scraps from jam
clearance areas. Close the front door.
HCS open door fault049-940
Check the position of the Stacker Tray
/ Cart.
Stacker Tray / Cart fault049-941
Remove paper from the Top Tray.Stacker Top Tray fault049-945
Remove paper from the Stacker Tray /
Cart.
Stacker Tray / Cart fault049-960, 049-964
Open the HCS front door and remove
any paper from the Stacker cart. Close
the door to resume operation.
Stacker Full Detection fault049-965 to 049-972
Xerox
®
Versant
®
80 Press23-4
User Guide
High Capacity Stacker (HCS)
To Next Page
Loading...
