Xerox Versant 80 Press - Fault Codes - GBC Advancedpunch

Recommended SolutionPossible CauseFault Code
1. Ensure all jams are cleared.
2. Ensure all handles / levers
are returned to closed pos-
ition.
3. Power Off / On the press.
4. If error persists, contact
the Customer Support
Center.
Communication failure or connec-
tion failure
048-320 to 048-324
1. Open the Module front
door.
2. Remove all sheets or
pieces from the jam clear-
ance areas.
3. Close the front door.
4. Verify that the paper be-
ing used is within specifica-
tions.
Sheets remain in the paper path
area
048-900, 048-901, 048-
903
Fault Codes - GBC AdvancedPunch
Fault codes for the GBC AdvancedPunch are displayed on the press User Interface /
Control Panel as an AdvancedPunch fault code.
RemedyCauseFault Code
1. Open AdvancedPunch front door
and look for a paper jam.
2. Remove any paper jam.
3. Close front door.
Jam is detected in the Advanced-
Punch.
040-100
040-101
040-900
040-901
Close front door of the AdvancedPunch.Front door of the Advanced-
Punch is not closed.
040-300
Install punch die set or fully insert it; close
front door.
The punch die set is missing or
not fully installed.
040-940
Install and / or fully insert punch container;
close front door.
Punch container is missing or
not fully installed.
040-941
Empty punch container and then reinstall
it.
Punch container is full.040-942
14-27Xerox
®
Versant
®
80 Press
User Guide
Press Problem Solving