Xerox Versant 80 Press - Cleaning the Exterior of the Advancedpunch Pro; Emptying the Punch Container

Reorder QuantityCRUs (Supply Item)
1 per boxDie Set, Xerox, Wire 3.1 Square
1 per boxDie Set, Xerox, Wire 2.1 Square
1 per boxDie Set, Xerox, Wire, 3:1, Round
1 per boxDie Set, Xerox, Wire, 2:1, Round
1 per boxDie Set, Xerox, Coil, Round
1 per boxDie Set, Xerox, Velobind, 11 Holes, Letter (8.5
x 11 inch)
1 per boxDie Set, Xerox, Velobind, 12 Holes, A4.
1 per boxDie Set, Xerox, 3 Hole, 8 mm
1 per boxDie Set,Xerox, 3/5/7 Hole, 8 mm
1 per boxDie Set, Xerox, 4 Hole, 8 mm
1 per boxDie Set, Xerox, 4 Hole, 6.5 mm
1 per boxDie Set, Xerox, 4 Hole, Scan
Cleaning the Exterior of the AdvancedPunch Pro
• Clean the exterior of the AdvancedPunch Pro using only a soft, damp cloth.
• Do not use detergents or solvents as damage to the punch may occur.
Emptying the Punch Container
The Punch Container for the AdvancedPunch Pro is located at the front of the unit base.
• The AdvancedPunch Pro uses a sensor to determine when the Punch Container is full.
22-21Xerox
®
Versant
®
80 Press
User Guide
GBC AdvancedPunch Pro