Xerox Versant 80 Press - OHCF (Trays 8 and 9) Jam Clearance; Clearing OHCF (Trays 8; 9) Jams; Paper Jams When the Bypass Is Installed on Trays 8 and 9

Recommended SolutionPossible CauseFault CodeFault Area
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Power Off / On the press.
4. If problem still persists, contact
the Customer Support Center.
General tray malfunc-
tion
178-217, 178-
218, 178-[224-
229], 178-230,
178-232, 178-
250, 178-251,
178-[260-281],
178-[285-291],
178-[293-294],
178-298
Trays 8, 9 and
Bypass
Close the front door / cover of the OHCF.OHCF Front Door
Open
178-304Trays 8 and 9
Replace the feed rolls; refer to Replacing
the OHCF Feed Rolls for the OHCF
(Trays 8 and 9)
An OHCF feed, nudger,
or retard roll is near
end of life
178-400 - 178-
405
Trays 8 and 9
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Power Off / On the press.
4. If problem still persists, contact
the Customer Support Center.
Multiple feed of
sheets / paper jam
178-900 - 178-
904
Trays 8 and 9
OHCF (Trays 8 and 9) Jam Clearance
Clearing OHCF (Trays 8 / 9) Jams
Nip Release levers inside of the Transport area of the Feeder hold back large size sheets
(such as A3, 11 x 17 inches, 12 x 18 inches) to reduce the chance of jamming as paper
enters the print engine.
Note
Follow the jam clearance instructions displayed on the touch screen. Always ensure that
all paper jams, including any small ripped pieces of paper, are cleared before proceeding
with your print jobs.
Paper Jams When the Bypass is Installed on Trays 8 and 9
Tip
Always ensure that all paper jams, including any small, ripped pieces of paper, are cleared
before proceeding with any print jobs.
1. Remove the paper currently loaded in the Bypass (Tray 5).
Xerox
®
Versant
®
80 Press18-10
User Guide
Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)