Xerox Versant 80 Press - Page 247

Recommended SolutionPossible CauseFault CodeFault Area
1. Fan the paper to eliminate pa-
per adhesion (especially in high
humidity or high temperature
environments).
2. Check the position of Skew Ad-
justment Levers. The levers
should be retracted.; refer to
Skew Adjustment Levers (Trays
8 and 9).
3. Replace the tray feed rolls (feed,
retard, nudger); refer to Repla-
cing the OHCF Feed Rolls for the
OHCF (Trays 8 and 9).
4. If problem persists, Call for ser-
vice.
Repetitive misfeeds or
multifeeds
078-125, 078-
126, 078-127,
178-106, 178-
156
Trays 8 and 9
Perform the following in this order:
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Power Off / On the press.
4. If problem still persists, contact
the Customer Support Center.
Gate sensor not
turned on fault during
paper transportation
from Tray 8
178-112Tray 8
Perform the following in this order:
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Power Off / On the press.
4. If problem still persists, contact
the Customer Support Center.
Gate sensor not
turned on fault during
paper transportation
from Tray 9
178-113Tray 9
Perform the following in this order:
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Replace the OHCF Feed Rolls;
refer to Replacing the OHCF
Feed Rolls for the OHCF (Trays
8 and 9).
Pre-registration or
feed sensor jam dur-
ing paper transporta-
tion from Tray 9
178-150, 178-
151
Tray 9
18-9Xerox
®
Versant
®
80 Press
User Guide
Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)