Xerox Versant 80 Press - Die Set Procedures; Removing Pins from a die Set

Removing Pins from a Die Set
Adding Pins to a Die Set
Die Stop Position
Changing the Die Stop Position
Die Set Procedures
Removing Pins from a Die Set
Important
Before removing pins from any die set, always refer to the Pin Removal Table for US
Paper Sizes and the Pin Removal Table for ISO Paper Sizes; this ensures that the correct
pins are being removed from the die set.
Use the following procedure to remove pins from a die set.
1. Rotate the two Quarter Turn Fasteners counter-clockwise to release the Pressure
Bar.
2. Remove the Pressure Bar and set aside.
3. Lift up and remove the appropriate pins according to either the Pin Removal Table
for US Paper Sizes or the Pin Removal Table for ISO Paper Sizes.
4. Store the pins in the pin storage tray inside the Front Door of the AdvancedPunch
Pro.
Important
Ensure that the pins cannot be dropped, damaged, or lost while stored.
5. Replace the Pressure Bar by performing the following steps:
a) Line up the two Dowel Pin Holes with the exposed Dowel Pins.
22-17Xerox
®
Versant
®
80 Press
User Guide
GBC AdvancedPunch Pro