Xerox Versant 80 Press - Finisher Module Maintenance Procedures; Standard Finisher Plus Problem Solving; Fault Codes - Standard Finisher Plus

Supply Unit Shipped with finisher/Reorder QuantitySupply Item
4 staple cartridges (5000 staples per cartridge) and 1 staple
waste container per carton
Standard Staple Cartridge and
Staple Waste Container
Finisher Module Maintenance Procedures
For detailed instructions on maintaining the Finisher Module, refer to the following
procedures:
• Replacing the Standard Staple Cartridge
• Replacing the Staple Waste Container
• Emptying the Punch Waste Container
Standard Finisher Plus Problem Solving
Fault Codes - Standard Finisher Plus
Recommended SolutionPossible CauseFault Code
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
The sensor or exit sensor in the
Finishing Transport did not
switch ON or did not switch OFF
within a specified amount of
time
013-108 to 013-110
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
Paper jam at the transport
sensor or exit sensor (Finishing
Transport)
013-910, 013-911
26-5Xerox
®
Versant
®
80 Press
User Guide
Standard Finisher Plus