Xerox Versant 80 Press - Page 370

Recommended SolutionPossible CauseFault Code
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
Paper jam051-100 to 051-111,
051-900
Power Off / On the press and resend /
rescan the job. If the fault persists, con-
tact the Customer Support Center.
Registration clutch solenoid
fault
051-210
Power Off / On the press and resend /
rescan the job. If the fault persists, con-
tact the Customer Support Center.
Diverter solenoid fault051-211
Close the front door of the Finishing
Transport.
Finishing Transport front door
is open
051-300
Power Off / On the press and resend /
rescan the job. If the fault persists, con-
tact the Customer Support Center.
Finishing Transport firmware
fault upgrade
051-310
1. Refer to the DFA device user
documentation and follow in-
structions to bring the device
back online.
2. Power Off / On the press and re-
send / rescan the job.
3. If the fault persists, contact the
Customer Support Center.
Either the DFA device is not
ready or another fault has oc-
curred with it
051-910, 051-911
Refer to the DFA device user document-
ation and follow instructions on how to
clear the fault and replenish the supplies.
The DFA device is either full or
out of supplies
051-912
Xerox
®
Versant
®
80 Press26-6
User Guide
Standard Finisher Plus