Xerox Versant 80 Press - Fault Codes - Standard Finisher Plus

Recommended solutionPossible causeFault code
• Pull open the container and empty any
trimmer scraps from it.
• Reinsert the container into the module.
• Make sure the container is pushed in
completely.
• If fault persists, power off/on the press.
• If fault persists, call for service.
The Trimmer Waste Contain-
er is full or has a fault
013-940
Fault Codes - Standard Finisher Plus
Recommended SolutionPossible CauseFault Code
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
The sensor or exit sensor in the
Finishing Transport did not
switch ON or did not switch OFF
within a specified amount of
time
013-108 to 013-110
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
Paper jam at the transport
sensor or exit sensor (Finishing
Transport)
013-910, 013-911
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
Paper jam051-100 to 051-111,
051-900
14-33Xerox
®
Versant
®
80 Press
User Guide
Press Problem Solving