Xerox Versant 80 Press - Page 196

Recommended SolutionPossible CauseFault Code
Power Off / On the press and resend /
rescan the job. If the fault persists, con-
tact the Customer Support Center.
Registration clutch solenoid
fault
051-210
Power Off / On the press and resend /
rescan the job. If the fault persists, con-
tact the Customer Support Center.
Diverter solenoid fault051-211
Close the front door of the Finishing
Transport.
Finishing Transport front door
is open
051-300
Power Off / On the press and resend /
rescan the job. If the fault persists, con-
tact the Customer Support Center.
Finishing Transport firmware
fault upgrade
051-310
1. Refer to the DFA device user
documentation and follow in-
structions to bring the device
back online.
2. Power Off / On the press and re-
send / rescan the job.
3. If the fault persists, contact the
Customer Support Center.
Either the DFA device is not
ready or another fault has oc-
curred with it
051-910, 051-911
Refer to the DFA device user document-
ation and follow instructions on how to
clear the fault and replenish the supplies.
The DFA device is either full or
out of supplies
051-912
1. Refer to the DFA device user
documentation and follow in-
structions on how to clear the
fault.
2. Set or change the profile value
(refer to the DFA user document-
ation).
3. Power Off / On the press and re-
send / rescan the job.
4. If the fault persists, contact the
Customer Support Center.
Paper jam in the DFA device051-913, 051-914,
051-915
Xerox
®
Versant
®
80 Press14-34
User Guide
Press Problem Solving