Xerox Versant 80 Press - Fault Codes - Interface Module; Interface Cooling Module

Recommended SolutionPossible CauseFault Code
1. Power Off / On the press.
2. If error persists, contact
the Customer Support
Center.
Problems in the finisher punch012-231 - 012-234,
012-247, 024-926, 024-
963, 112-700
1. Power Off / On the press.
2. If error persists, contact
the Customer Support
Center.
Problems in the optional booklet
maker
012-243, 012-246, 012-
265, 012-266, 012-269,
012-292, 012-297, 012-
307, 012-319, 012-983,
012-984, 012-989
1. Power Off / On the press.
2. If error persists, contact
the Customer Support
Center.
Problems with the finisher stapler
or booklet stapler
012-291, 012-295, 012-
296 - 024-979, 024-
987, 024-988, 124-711,
124-712, 124-713
Fault Codes - Interface Module / Interface Cooling Module
Recommended SolutionPossible CauseFault Code
1. Open the Module front
door.
2. Remove all sheets or
pieces from the jam clear-
ance areas.
3. Close the front door.
4. Verify that the paper be-
ing used is within specifica-
tions.
Paper Jam during feeding048-100 to 048-107
Ensure door is fully closed.Module front door is open048-300
1. Power Off / On the press.
2. If error persists, contact
the Customer Support
Center.
Decurler Sensor or Belt issue048-310, 048-311, 048-
312, 048-313, 048-314,
048-315, 048-316
1. Power Off / On the press.
2. If error persists, contact
the Customer Support
Center.
Cooling fan failure048-317, 048-318, 048-
319
Xerox
®
Versant
®
80 Press14-26
User Guide
Press Problem Solving