Xerox Versant 80 Press - GBC Advancedpunch Problem Solving; Fault Codes - GBC Advancedpunch; GBC Advancedpunch General Problems

GBC AdvancedPunch Problem Solving
Fault Codes - GBC AdvancedPunch
Fault codes for the GBC AdvancedPunch are displayed on the press User Interface /
Control Panel as an AdvancedPunch fault code.
RemedyCauseFault Code
1. Open AdvancedPunch front door
and look for a paper jam.
2. Remove any paper jam.
3. Close front door.
Jam is detected in the Advanced-
Punch.
040-100
040-101
040-900
040-901
Close front door of the AdvancedPunch.Front door of the Advanced-
Punch is not closed.
040-300
Install punch die set or fully insert it; close
front door.
The punch die set is missing or
not fully installed.
040-940
Install and / or fully insert punch container;
close front door.
Punch container is missing or
not fully installed.
040-941
Empty punch container and then reinstall
it.
Punch container is full.040-942
Empty punch container and then reinstall
it.
Punch container is near full.140-700
GBC AdvancedPunch General Problems
RemedyCause
1. Check that the power cord is attached to the
back of the unit.
2. Ensure that the power cord is plugged into the
wall outlet.
3. Ensure that the AdvancedPunch power is
switched on.
4. If the problem continues, contact the Custom-
er Support Center.
No power or will not punch
21-7Xerox
®
Versant
®
80 Press
User Guide
GBC AdvancedPunch