Recommended SolutionPossible CauseFault CodeFault Area
Perform the following in this order:
1. Remove or clear any
jammed paper.
2. Replace and fan the paper
in tray.
3. Replace the OHCF Feed
Rolls; refer to Replacing the
OHCF Feed Rolls (Trays 6
and 7).
Pre-registration sensor
jam; during paper trans-
portation, feed sensor is
not turned on within peri-
od of time paper is trans-
porting from tray
078-100,
078-101,
078-102,
078-103
Tray 6
Perform the following in this order:
1. Remove or clear any
jammed paper.
2. Replace and fan the paper
in tray.
3. Replace the OHCF Feed
Rolls; refer to Replacing the
OHCF Feed Rolls (Trays 6
and 7).
Pre-registration or feed
sensor jam during paper
transportation from Tray
7
078-150,
078-151
Tray 7
Perform the following in this order:
1. Remove or clear any
jammed paper.
2. Replace and fan the paper
in tray.
3. Power Off / On the press.
4. If problem still persists,
contact the Customer Sup-
port Center.
Regi sensor not turned on
fault during paper trans-
portation from Tray 6
078-102Tray 6
Regi sensor not turned on
fault during paper trans-
portation from Tray 7
078-156Tray 7
General tray malfunction078-2[00-
99], 078-
3[00-99],
078-4[00-
99], 078-
6[00-99],
078-9[00-
99]
Trays 6 and 7
17-7Xerox
®
Versant
®
80 Press
User Guide
1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)
To Next Page
Loading...
