Stratus OCT User Manual PN 2660021134133 A
Configuration Guide
B-23
Note: To find the review station computer name:
• On systems running Windows 2000, right-click on the My Computer desktop icon and
select Properties. Then select Network Identification to find the computer name.
• On systems running Windows XP, select Start, right-click My Computer and select
Properties. Then select Computer Name to view the computer name.
Note: You must use two backslashes before the computer name as shown in the
example.
Note: You must select the Reconnect at logon checkbox to allow the system to
reconnect to the shared drive each time Windows starts.
4. Click Finish to save your changes and close the Map Network Drive dialog.
The new drive letter will now be available during the export process on the Stratus
instrument. In this example, the drive letter N: was mapped to the shared folder on the
review station. To export to the review station PC from the Stratus instrument, select the
mapped drive letter (N: in this case) as the export target. For more detail, refer to the
chapters on import and export in the Stratus OCT User Manual or Stratus OCT Review
Software User Manual.
Import Data from the Local Shared Folder
To have access in Stratus Review Software to the data exported from the instrument, you
must complete the process by importing it from the local shared folder you created as
described above. For details, see
Import Data on page 9-10.
Reconnecting Review Station to a Preexisting Network
To reconnect the review station to a preexisting network, disconnect the crossover cable,
reconfigure the Local Area Connection’s TCP/IP properties to what they were before, and
stop sharing the shared folder. If the data folder is shared on a preexisting network, it may
be visible to all network users and the Internet. When not connected to the Stratus OCT, we
strongly recommended that you disable sharing of the data folder.
To Next Page
Loading...
