Zeiss 3000 - On Stratus OCT, Map a Network Drive to the NAS Device

Stratus OCT User Manual PN 2660021134133 A
Using a Network Storage Device
E-3
1. With the Stratus OCT and the NAS device turned off, use a network patch cord to
connect the NAS device either directly to the Stratus OCT, or to the office network
(local area network or LAN) on which the Stratus OCT resides. Refer to the
manufacturer’s instructions for details regarding installation of the NAS device.

Note: For safety, observe the warnings and requirements on page E-1 that relate to
the type and length of cord.
2. Turn on the NAS device and wait for initialization to complete before you turn on the
Stratus OCT. Often a color change in a light on the front of the NAS device indicates
initialization is complete, but see the manufacturer’s instructions for details on
initialization.
3. Turn on the Stratus OCT. After you complete the startup process, exit the Stratus
software, going to the Windows
®
desktop.
• In the system tray at lower right, you may observe a Local Area Connection
notice resulting from attachment of the NAS device. Ignore the message at
this point.
4. In the Stratus OCT CD drive, install the CD that accompanies the NAS device, which
will install and run the NAS device configuration program. Follow the on-screen
instructions, using the default settings. While running the NAS device configuration,
observe the following recommendations:
A. Installation Type: If you are presented with an option to choose a type of
installation, for example a choice between “typical,” “minimal” and/or “custom”
installation, we recommend you choose “typical” or “minimal.” Do not perform a
“custom” installation unless you have reason to do so and the knowledge and
experience required, which would be equivalent to that of a network or system
administrator.
B. Record Storage Drive Name: If you are presented with the option to change the
name of the NAS device, you can either use the default name or change it at your
discretion, but in either case, you must write it down, because you may need it to
complete configuration on the Stratus OCT. You can use the space below:
NAS Device Name (also known as Network ID):
C. Workgroup Name Must Match Stratus OCT Workgroup Name: If you are presented
with the option to change the workgroup name of the NAS device, you must make
it match the workgroup name of the Stratus OCT, which is “CZM” by default—this
name is not case-sensitive on Stratus OCT. If the Stratus OCT is connected to an
office network as part of a different workgroup name, then you must use that
workgroup name.
5. When you complete NAS device configuration, exit the configuration program and
remove the CD from the Stratus OCT CD drive.
On Stratus OCT, Map a Network Drive to the NAS Device
In some cases, the configuration software of the NAS device automatically maps the
correct folder of the NAS device to a drive letter on the Stratus OCT. When this is the case,