ZyXEL Communications P-792H - Page 38

Chapter 3 Status Screens
P-792H v2 User’s Guide
38
Each field is described in the following table.
Table 4 Status Screen
LABEL DESCRIPTION
Refresh Interval Select how often you want the P-792H v2 to update this screen.
Apply Click this to update this screen immediately.
Device Information
Host Name This field displays the P-792H v2 system name. It is used for
identification. You can change this in the Maintenance > System >
General screen’s System Name field.
Model
Number
This is the model name of your device.
MAC
Address
This is the MAC (Media Access Control) or Ethernet address unique to
your P-792H v2.
ZyNOS
Firmware
Version
This is the current version of the firmware inside the device. It also
shows the date the firmware version was created. Click this to go to the
screen where you can change it.
DSL
Firmware
Version
This is the current version of the device’s DSL modem code.
WAN Information
DSL Mode This is the DSL standard that your P-792H v2 is using.
IP Address This is the current IP address of the P-792H v2 in the WAN. Click this to
go to the screen where you can change it.
IP Subnet
Mask
This is the current subnet mask in the WAN.
Default
Gateway
This is the IP address of the default gateway, if applicable.
VPI/VCI This is the Virtual Path Identifier and Virtual Channel Identifier that you
entered in the wizard or WAN screen.
LAN Information
IP Address This is the current IP address of the P-792H v2 in the LAN. Click this to
go to the screen where you can change it.
IP Subnet
Mask
This is the current subnet mask in the LAN.
DHCP This field displays what DHCP services the P-792H v2 is providing to the
LAN. Choices are:
Server - The P-792H v2 is a DHCP server in the LAN. It assigns IP
addresses to other computers in the LAN.
Relay - The P-792H v2 acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the
clients.
None - The P-792H v2 is not providing any DHCP services to the LAN.
Click this to go to the screen where you can change it.
Security
Firewall This displays whether or not the P-792H v2’s firewall is activated. Click
this to go to the screen where you can change it.