Chapter 3 Status Screens
P-792H v2 User’s Guide
39
Content
Filter
This displays whether or not the P-792H v2’s content filtering is
activated. Click this to go to the screen where you can change it.
System Status
System
Uptime
This field displays how long the P-792H v2 has been running since it last
started up. The P-792H v2 starts up when you plug it in, when you
restart it (Maintenance > Tools > Restart), or when you reset it.
Current
Date/Time
This field displays the current date and time in the P-792H v2. You can
change this in Maintenance > System > Time Setting.
System
Mode
This displays whether the P-792H v2 is functioning as a router or a
bridge.
CPU Usage This field displays what percentage of the P-792H v2’s processing ability
is currently used. When this percentage is close to 100%, the P-792H
v2 is running at full load, and the throughput is not going to improve
anymore. If you want some applications to have more throughput, you
should turn off other applications (for example, using QoS; see Chapter
15 on page 201).
Memory
Usage
This field displays what percentage of the P-792H v2’s memory is
currently used. Usually, this percentage should not increase much. If
memory usage does get close to 100%, the P-792H v2 is probably
becoming unstable, and you should restart the device. See Section 21.4
on page 279, or turn off the device (unplug the power) for a few
seconds.
Interface Status
Interface This column displays each interface the P-792H v2 has.
Status This field indicates whether or not the P-792H v2 is using the interface.
For the DSL interface, this field displays Down (line is down), Up (line
is up or connected) if you're using Ethernet encapsulation and Down
(line is down), Up (line is up or connected), Idle (line (ppp) idle), Dial
(starting to trigger a call) and Drop (dropping a call) if you're using
PPPoE encapsulation.
For the LAN interface, this field displays Up when the P-792H v2 is
using the interface and Down when the P-792H v2 is not using the
interface.
Rate For the LAN interface, this displays the port speed and duplex setting.
For the DSL interface, it displays the downstream and upstream
transmission rate.
Summary
Client List Click this link to view current DHCP client information. See Section 7.4
on page 92.
VPN Status Click this link to view the status of any VPN tunnels the P-792H v2 has
negotiated. See Section 3.4 on page 40.
AnyIP Table Click this link to view a list of IP addresses and MAC addresses of
computers, which are not in the same subnet as the P-792H v2. See
Section 3.5 on page 40.
Packet
Statistics
Click this link to view port status and packet specific statistics. See
Section 3.6 on page 41.
Table 4 Status Screen
LABEL DESCRIPTION
To Next Page
Loading...
