3Com Baseline 2928 PWR Plus - Configuring a VLAN; Configuration Task List; Creating Vlans

1-4
Configuring a VLAN
Configuration Task List
Use one of the following two approaches or combine the following two approaches to configure a VLAN:
z Approach I: modify a VLAN, as shown in Table 1-1.
z Approach II: modify a port, as shown in Table 1-2.
Table 1-1 VLAN configuration task list (approach I)
Task Remarks
Creating VLANs
Required
Create one or multiple VLANs
Selecting VLANs
Required
Reduce the range of VLANs available for selection during related
operations, that is, configure a subset of all existing VLANs. This step
is required before displaying, modifying, or removing a VLAN.
Modifying a VLAN
Required
Configure the untagged member ports and tagged member ports of the
VLAN, or remove the specified ports from the VLAN.
Table 1-2 VLAN configuration task list (approach II)
Task Remarks
Creating VLANs
Required
Create one or multiple VLANs
Modifying Ports
Required
Configure ports as the untagged members or tagged members of
VLANs, or remove ports from VLANs; configure the link type and PVID
of the ports.
Creating VLANs
Select Network > VLAN from the navigation tree and click Create to enter the page for creating VLANs,
as shown in
Figure 1-4.