3Com Baseline 2928 PWR Plus - Configuring a Port; Port Management Configuration

1-1
1 Port Management Configuration
Overview
You can use the port management feature to set and view the operation parameters of a Layer 2
Ethernet port, including but not limited to its state, rate, duplex mode, link type, PVID, MDI mode, flow
control settings, MAC learning limit, and storm suppression ratios.
Configuring a Port
Setting Operation Parameters for a Port
Select Device > Port Management from the navigation tree, and then select the Setup tab on the page
that appears to enter the page as shown in
Figure 1-1.
Figure 1-1 The Setup tab