3Com Baseline 2928 PWR Plus - Configuring a Time Range

1-4
Configuring a Time Range
Select QoS > Time Range from the navigation tree and then select the Create tab to enter the time
range configuration page, as shown in
Figure 1-1.
Figure 1-1 The page for creating a time range
Table 1-4 describes the configuration items for creating a time range.
Table 1-4 Time range configuration items
Item Description
Time Range Name Set the name for the time range.
Start Time Set the start time of the periodic time range.
End Time
Set the end time of the periodic time range. The end
time must be greater than the start time.
Periodic
Time
Range
Sun, Mon,
Tue, Wed,
Thu, Fri, and
Sat.
Select the day or days of the week on which the
periodic time range is valid. You can select any
combination of the days of the week.
From
Set the start time and date of the absolute time range.
The time of the day is in the hh:mm format (24-hour
clock), and the date is in the MM/DD/YYYY format.
Absolute
Time
Range
To
Set the end time and date of the absolute time range.
The time of the day is in the hh:mm format (24-hour
clock), and the date is in the MM/DD/YYYY format.
The end time must be greater than the start time.
You can
define both a
periodic time
range and an
absolute time
range to
create a
compound
time range.
This
compound
time range
recurs on the
day or days of
the week only
within the
specified
period.