1-3
Trace Route Operation
z The Web interface supports trace route on IPv4 addresses only.
z Before performing the trace route operation on the Web interface, on the device execute the
commands of ip ttl-expires enable and ip unreachables enable to enable the sending of ICMP
timeout and destination unreachable packets.
Select Network > Diagnostic Tools from the navigation tree and then select the Trace Route to enter
the Trace Route configuration page, as shown in
Figure 1-3.
Figure 1-3 Trace Route configuration page
Type the destination IP address in the Trace Route text box, and click Start to execute the trace route
command. You will see the result in the Result area, as shown in
Figure 1-4.
Figure 1-4 Trace route operation result
To Next Page
Loading...
