3Com Baseline 2928 PWR Plus - Configuring Line Rate on a Port

2-23
Table 2-19 describes the configuration items of configuring queue scheduling on a port.
Table 2-19 Configuration items of configuring queue scheduling on a port
Item Description
WRR
Enable or disable the WRR queue scheduling mechanism on selected
ports. Two options are available:
z Enable: Enables WRR on selected ports.
z Not Set: Restores the default queuing algorithm on selected ports.
Queue
Select the queue to be configured.
Its value range is 0 to 7, but only 0 to 3 is user configurable and 4 to 7 are
reserved.
Group
Specify the group the current queue is to be assigned to.
This drop-down list is available after you select a queue ID. The following
groups are available for selection:
z SP: Assigns a queue to the SP group.
z 1: Assigns a queue to WRR group 1.
z 2: Assigns a queue to WRR group 2.
WRR
Setup
Weight
Set a weight for the current queue.
This option is available when group 1 or group 2 is selected.
Please select port(s)
Click to select ports to be configured with queuing on the chassis front
panel.
Return to
Queue scheduling configuration task list.
Configuring Line Rate on a Port
Select QoS > Line rate from the navigation tree and click the Setup tab to enter the line rate
configuration page, as shown in
Figure 2-20.