3Com Baseline 2928 PWR Plus - Authorized Ip Configuration Example

1-2
Authorized IP Configuration Example
Authorized IP Configuration Example
Network requirements
In Figure 1-2, configure Switch to deny telnet and HTTP requests from Host A , while permit telnet and
HTTP requests from Host B.
Figure 1-2 Network diagram for authorized IP
Configuration procedure
# Create an ACL.
z Select QoS > ACL IPv4 from the navigation tree and then click the Create tab to enter the ACL
configuration page shown in
Figure 1-3.
Figure 1-3 Create an ACL
Make the following configurations on the page:
z Type 2001 for ACL Number.
z Click Apply.
# Configure an ACL rule to permit Host B.
z Click the Basic Setup tab to enter the page shown in Figure 1-4.