3Com Baseline 2928 PWR Plus - SNMP Configuration Example

1-13
Return to SNMPv1 or SNMPv2c configuration task list or SNMPv3 configuration task list.
SNMP Configuration Example
Network requirements
z As shown in Figure 1-17, the NMS connects to the agent, Switch, through an Ethernet.
z The IP address of the NMS is 1.1.1.2/24.
z The IP address of the VLAN interface on Switch is 1.1.1.1/24.
z The NMS monitors the agent using SNMPv3. The agent reports errors or faults to the NMS. The
NMS uses port 5000 to receive traps.
Figure 1-17 Network diagram for SNMP configuration
Configuration procedure
1) Configure Agent
# Configuration IP addresses for the interfaces. (Omitted)
# Enable SNMP.
Select Device > SNMP from the navigation tree, and you will enter the Setup page as shown in
Figure
1-18.
Figure 1-18 Enable SNMP
z Select the Enable radio box.
z Select the v3 radio box.
z Click Apply.
# Configure an SNMP view.
z Click the View tab and then click Add to enter the page as shown in Figure 1-19.