3Com Baseline 2928 PWR Plus - Creating a Mirroring Group

1-2
Perform the tasks described in Table 1-1 to configure local port mirroring:
Table 1-1 Local port mirroring configuration task list
Task Remarks
Create a local mirroring group
Required
Refer to section
Creating a Mirroring Group for details.
Configure the mirroring ports
Required
Refer to section
Configuring Ports for a Mirroring Group for
details.
During configuration, you need to select the port type Mirror Port.
You can configure multiple mirroring ports for a mirroring group.
Configure the monitor port
Required
Refer to section
Configuring Ports for a Mirroring Group for
details.
During configuration, you need to select the port type Monitor
Port. You can configure one only monitor port for a mirroring
group.
Creating a Mirroring Group
Select Device > Port Mirroring from the navigation tree and click Create to enter the page for creating
a mirroring group, as shown in
Figure 1-2.
Figure 1-2 Create a mirroring group
Table 1-2 describes the configuration items of creating a mirroring group.