1-4
Table 1-2 Management IP address configuration items
Item Description
Select VLAN
Interface
Select a VLAN interface.
Available VLAN interfaces are those configured in the page you enter by selecting
Network > VLAN Interface and selecting the Create tab.
Admin
Status
Enable or disable the VLAN interface.
When errors occurred on the VLAN interface, disable the interface and then enable
the port to bring the port to work properly.
By default, the VLAN interface is down if no Ethernet ports in the VLAN is up. The
VLAN is in the up state if one or more ports in the VLAN are up.
Disabling or enabling the VLAN interface does not affect the status of the Ethernet
ports in the VLAN. That is, the port status does not change with the VLAN interface
status.
DHCP
BOOTP
Manual
Configure how the VLAN interface obtains an IPv4 address.
z DHCP: Specifies the VLAN interface to obtain an IPv4 address
by DHCP.
z BOOTP: Specifies the VLAN interface to obtain an IPv4 address
through BOOTP.
z Manual: Allows you to specify an IPv4 address and a mask
length.
Support for IPv4 obtaining methods depends on the device model.
IPv4 address
Configure
IPv4
address
MaskLen
Specify an IPv4 address and the mask length for the VLAN interface.
These two text boxes are configurable if Manual is selected.
Finishing Configuration Wizard
After finishing the management IP address configuration, click Next, as shown in Figure 1-4.
To Next Page
Loading...
