3Com Baseline 2928 PWR Plus - Creating a Static ARP Entry; Static ARP Configuration Example

1-4
Creating a Static ARP Entry
Select Network > ARP Management from the navigation tree to enter the default ARP Table page
shown in
Figure 1-3. Click Add to enter the New Static ARP Entry page. Select the Advanced
Options checkbox to expand advanced configuration items, as shown in
Figure 1-4.
Figure 1-4 Add a static ARP entry
Table 1-1 describes the static ARP entry configuration items.
Table 1-1 Static ARP entry configuration items
Item Description
IP Address Type an IP address for the static ARP entry.
MAC Address Type a MAC address for the static ARP entry.
VLAN ID
Advanced
Options
Port
Type a VLAN ID and specify a port for the static ARP entry.
The VLAN ID must be the ID of the VLAN that has already been created,
and the port must belong to the VLAN. The corresponding VLAN interface
must have been created.
Static ARP Configuration Example
Network Requirements
As shown in Figure 1-5, hosts are connected to Switch A, which is connected to Router B through
interface GigabitEthernet 1/0/1 belonging to VLAN 100. The IP address of Router B is 192.168.1.1/24.
The MAC address of Router B is 00e0-fc01-0000.
To enhance communication security between Switch A and Router B, static ARP entries need to be
configured on Switch A.