1-4
Task Remarks
Configuring an SNMP Community Required
Configuring SNMP Trap Function
Optional
Allows you to configure that the agent can send SNMP traps
to the NMS, and configure information about the target host
of the SNMP traps.
By default, an agent is allowed to send SNMP traps to the
NMS.
Configuring SNMPv3
Perform the tasks in Table 1-2 to configure SNMPv3:
Table 1-2 SNMPv3 configuration task list
Task Remarks
Enabling SNMP
Required
The SNMP agent function is disabled by default.
Configuring an SNMP View
Optional
After creating SNMP views, you can specify an SNMP view for
an SNMP group to limit the MIB objects that can be accessed by
the SNMP group.
Configuring an SNMP Group
Required
After creating an SNMP group, you can add SNMP users to the
group when creating the users. Therefore, you can realize
centralized management of users in the group through the
management of the group.
Configuring an SNMP User
Required
Before creating an SNMP user, you need to create the SNMP
group to which the user belongs.
Configuring SNMP Trap Function
Optional
Allows you to configure that the agent can send SNMP traps to
the NMS, and configure information about the target host of the
SNMP traps
By default, an agent is allowed to send SNMP traps to the NMS.
Enabling SNMP
Select Device > SNMP from the navigation tree to enter the SNMP configuration page, as shown in
Figure 1-4. On the upper part of the page, you can select to enable or disable SNMP and configure
parameters such as SNMP version; on the lower part of the page, you can view the SNMP statistics,
which helps you understand the running status of the SNMP after your configuration.
To Next Page
Loading...
