2-24
Figure 2-20 The page for configuring line rate on a port
Table 2-20 describes the configuration items of configuring line rate on a port.
Table 2-20 Configuration items of configuring line rate on a port
Item Description
Please select an interface type
Select the types of interfaces to be configured with line rate.
The interface types available for selection depend on your device
model.
Rate Limit Enable or disable line rate on the specified port.
Direction
Select a direction in which the line rate is to be applied.
z Inbound: Limits the rate of packets received on the specified
port.
z Outbound: Limits the rate of packets sent by the specified
port.
z Both : Limits the rate of packets received on and sent by the
specified port.
CIR Set the committed information rate (CIR), the average traffic rate.
Please select port(s)
Specify the ports to be configured with line rate
Click the ports to be configured with line rate in the port list. You
can select one or more ports.
Return to
Line rate configuration task list.
Configuring Priority Mapping Tables
Select QoS > Priority Mapping from the navigation tree to enter the page shown in Figure 2-21.
To Next Page
Loading...
