1-5
Figure 1-4 Set up
Table 1-3 describes the configuration items for enabling SNMP.
Table 1-3 Configuration items for enabling SNMP
Item Description
SNMP Specify to enable or disable SNMP.
Local Engine ID
Configure the local engine ID.
The validity of a user after it is created depends on the engine ID of the
SNMP agent. If the engine ID when the user is created is not identical to
the current engine ID, the user is invalid.
Maximum Packet Size
Configure the maximum size of an SNMP packet that the agent can
receive/send.
Contact
Set a character string to describe the contact information for system
maintenance.
If the device is faulty, the maintainer can contact the manufacture
factory according to the contact information of the device.
Location Set a character string to describe the physical location of the device.
SNMP Version Set the SNMP version run by the system
Return to
SNMPv1 or SNMPv2c configuration task list or SNMPv3 configuration task list.
Configuring an SNMP View
Select Device > SNMP from the navigation tree, and then click the View tab to enter the page as shown
in
Figure 1-5.
To Next Page
Loading...
