3Com Baseline 2928 PWR Plus - MAC Address Configuration Example

1-5
MAC Address Configuration Example
Network requirements
Use the MAC address table management function of the Web-based NMS. It is required to add a static
MAC address 00e0-fc35-dc71 under GigabitEthernet 1/0/1 in VLAN 1.
Configuration procedure
# Create a static MAC address entry.
Select Network > MAC from the navigation tree to enter the MAC tab, and then click Add, as shown in
Figure 1-2. The page shown in Figure 1-5 appears.
Figure 1-5 Create a static MAC address entry
Make the following configurations on the page shown in
Figure 1-5:
z Type in MAC address 00e0-fc35-dc71.
z Select static in the Type drop down list.
z Select 1 in the VLAN drop down list.
z Select GigabitEthernet1/0/1 in the Port drop down list.
z Click Apply.