3Com Baseline 2928 PWR Plus - Configuring MSTP on a Port

1-19
Configuring MSTP on a Port
Select Network > MSTP from the navigation tree, and then click Port Setup to enter the page for
configuring MSTP on ports, as shown in
Figure 1-9.
Figure 1-9 MSTP configuration on a port
Table 1-10 describes the configuration items of configuring MSTP on a port.
Table 1-10 Configuration items of configuring MSTP on a port
Item Description
STP Select whether to enable STP on the port
Protection
Set the type of protection to be enabled on the port:
z Not Set: No protection is enabled on the port.
z Edged Port, Root Protection, Loop Protection: Refer to Table 1-11.