3Com Baseline 2928 PWR Plus - Displaying Information of an Aggregate Interface; Setting LACP Priority

1-7
Displaying Information of an Aggregate Interface
Select Network > Link Aggregation from the navigation tree. The Summary tab is displayed by
default, as shown in
Figure 1-2.
Figure 1-2 Display information of an aggregate interface
Table 1-5 describes the fields on the Summary tab.
Table 1-5 Fields on the Summary tab
Field Description
Aggregation interface
Type and ID of the aggregate interface
Bridge-Aggregation indicates a Layer 2 aggregate interface
Link Type Type of the aggregate interface, which can be static or dynamic
Partner ID ID of the remote device, including its LACP priority and MAC address
Selected Ports
Number of selected ports in each link aggregation group (Only selected
ports can transmit and receive user data)
Standby Ports
Number of unselected ports in each link aggregation group (Unselected
ports cannot transmit or receive user data)
Return to
Static aggregation group configuration task list.
Return to
Dynamic aggregation group configuration task list.
Setting LACP Priority
Select Network > LACP from the navigation tree, and then click Setup to enter the page shown in
Figure 1-3.