3Com Baseline 2928 PWR Plus - Configuring and Displaying Clients IP-To-MAC Bindings; DHCP Relay Agent Configuration Example

2-6
Configuring and Displaying Clients' IP-to-MAC Bindings
Select Network > DHCP from the navigation tree to enter the default DHCP Relay page shown in
Figure 2-3. In the User Information field, click the User Information button to view static and dynamic
bindings, as shown in
Figure 2-6. Click Add to enter the page shown in Figure 2-7.
Figure 2-6 Display clients' IP-to-MAC bindings
Figure 2-7 Create a static IP-to-MAC binding
Table 2-4 describes static IP-to-MAC binding configuration items.
Table 2-4 Static IP-to-MAC binding configuration items
Item Description
IP Address Type the IP address of a DHCP client.
MAC Address Type the MAC address of the DHCP client.
Interface Name
Select the Layer 3 interface connected with the DHCP client.
The interface of a static binding entry must be configured as a DHCP
relay agent; otherwise, address entry conflicts may occur.
Return to
DHCP Relay Agent Configuration Task List.
DHCP Relay Agent Configuration Example
Network requirements
As shown in Figure 2-8, VLAN-interface 1 on the DHCP relay agent (Switch A) connects to the network
where DHCP clients reside. The IP address of VLAN-interface 1 is 10.10.1.1/24 and the IP address of