3Com Baseline 2928 PWR Plus - IRF Stack Configuration Example

1-6
Figure 1-5 Device summary (a slave device)
Return to
Stack configuration task list.
IRF Stack Configuration Example
Network requirements
z As shown in Figure 1-6, Switch A, Switch B, Switch C, and Switch D are connected with one
another.
z Create a stack, where Switch A is the master device, Switch B, Switch C, and Switch D are slave
devices. An administrator can log in to Switch B, Switch C and Switch D through Switch A to
perform remote configurations.
Figure 1-6 Network diagram for IRF stack
GE1/0/1
GE1/0/3
SwitchB: Slave device
GE1/0/1GE1/0/1
SwitchC: Slave device SwitchD: Slave device
Stack
GE1/0/1
GE1/0/2
SwitchA: Master device
Configuration procedure
1) Configure the master device
# Configure global parameters for the stack on Switch A.
z Select IRF from the navigation tree of Switch A to enter the page of the Setup tab, and then
perform the following configurations, as shown in
Figure 1-7.