3Com Baseline 2928 PWR Plus - Configuring an SNMP Community

1-7
Table 1-4 Configuration items for creating an SNMP view
Item Description
View Name Set the SNMP view name.
Rule
Select to exclude or include the objects in the view range determined by
the MIB subtree OID and subtree mask.
MIB Subtree OID
Set the MIB subtree OID (such as 1.4.5.3.1) or name (such as system).
MIB subtree OID identifies the position of a node in the MIB tree, and it can
uniquely identify a MIB subtree.
Subtree Mask
Set the subtree mask.
If no subtree mask is specified, the default subtree mask (all Fs) will be
used for mask-OID matching.
Adding rules to an SNMP view
Click the icon corresponding to the specified view on the page as shown in Figure 1-5, the Add rule
for the view ViewDefault window appears as shown in
Figure 1-8. After configuring the parameters,
click Apply to add the rule for the view.
Table 1-4 describes the configuration items for creating an
SNMP view.
Figure 1-8 Add rules to an SNMP view
You can also click the icon corresponding to the specified view on the page as shown in Figure 1-5,
and then you can enter the page to modify the view.
Return to
SNMPv1 or SNMPv2c configuration task list or SNMPv3 configuration task list.
Configuring an SNMP Community
Select Device > SNMP from the navigation tree, then click the Community tab to enter the page as
shown in
Figure 1-9. Click Add to enter the Add SNMP Community page as shown in Figure 1-10.