3Com Baseline 2928 PWR Plus - LLDP Configuration Examples; LLDP Basic Settings Configuration Example

1-20
Return to LLDP Configuration Task List.
Displaying LLDP Information Received from LLDP Neighbors
Select Network > LLDP from the navigation tree and click the Neighbor Summary tab to display the
global LLDP neighbor information, as shown in
Figure 1-13.
Figure 1-13 The Neighbor Summary tab
Return to
LLDP Configuration Task List.
LLDP Configuration Examples
LLDP Basic Settings Configuration Example
Network requirements
As shown in Figure 1-14, a network management station is connected to Switch A over Ethernet and
Switch A is connected to a MED device and Switch B through ports GigabitEthernet 1/0/1 and
GigabitEthernet 1/0/2 respectively.
Configure LLDP on Switch A and Switch B so that the network management station can determine the
link status of Switch A.
Figure 1-14 Network diagram for basic LLDP settings configuration