3Com Baseline 2928 PWR Plus - Enabling DHCP and Configuring Advanced Parameters for the DHCP Relay Agent

2-3
Task Remarks
Configuring and Displaying
Clients' IP-to-MAC Bindings
Optional
Create a static IP-to-MAC binding, and view static and dynamic
bindings.
The DHCP relay agent can dynamically record clients’
IP-to-MAC bindings after clients get IP addresses. It also
supports static bindings, that is, you can manually configure
IP-to-MAC bindings on the DHCP relay agent, so that users
can access external network using fixed IP addresses.
By default, no static binding is created.
Enabling DHCP and Configuring Advanced Parameters for the
DHCP Relay Agent
Select Network > DHCP from the navigation tree to enter the default DHCP Relay page. Enable or
disable DHCP in the DHCP Service field. Click Display Advanced Configuration to expand the
advanced DHCP relay agent configuration field, as shown in
Figure 2-3.
Figure 2-3 DHCP relay agent configuration page
Table 2-1 describes the DHCP service and advanced DHCP relay agent configuration items.