3Com Baseline 2928 PWR Plus - Voice VLAN Configuration Examples; Configuring Voice VLAN on a Port in Automatic Voice VLAN Assignment Mode

1-8
Item Description
Description Set the description of the OUI address entry.
Return to
Configuring voice VLAN on a port in automatic voice VLAN assignment mode.
Return to
Configuring voice VLAN on a port working in manual voice VLAN assignment mode.
Voice VLAN Configuration Examples
Configuring Voice VLAN on a Port in Automatic Voice VLAN Assignment Mode
Network requirements
z Configure VLAN 2 as the voice VLAN allowing only voice traffic to pass through.
z The IP phone connected to hybrid port GigabitEthernet 1/0/1 sends untagged voice traffic.
z GigabitEthernet 1/0/1 operates in automatic VLAN assignment mode. Set the voice VLAN aging
timer to 30 minutes.
z Configure GigabitEthernet 1/0/1 to allow voice packets whose source MAC addresses match the
OUI addresses specified by OUI address 0011-2200-0000 and mask ffff-ff00-0000. The description
of the OUI address entry is test.
Figure 1-4 Network diagram for configuring voice VLAN on a port working in automatic voice VLAN
assignment mode
Switch A Switch B
GE1/0/3
GE1/0/1
VLAN 2
VLAN 2
010-1001
OUI: 0011-2200-0000
Mask: ffff-ff00-0000
0755-2002
Internet
Configuration procedure
# Create VLAN 2.
z Select Network > VLAN from the navigation tree, and click Create on the displayed page to enter
the page shown in
Figure 1-5.