3Com Baseline 2928 PWR Plus - Setting the Aging Time of MAC Address Entries

1-4
Table 1-1 Configuration items of creating a MAC address entry
Item Description
MAC Set the MAC address to be added
Type
Set the type of the MAC address entry, which can be:
z static: indicates static MAC address entries that never age out
z dynamic: indicates dynamic MAC address entries that will age out
z blackhole: indicates blackhole MAC address entries that never age out
The types of the MAC address entries displayed in the tab are as follows:
z Config static: indicates static MAC address entries manually configured
by the users
z Config dynamic: indicates dynamic MAC address entries manually
configured by the users
z Blackhole: indicates blackhole MAC address entries
z Learned: indicates dynamic MAC address entries learned by the device
z Other: indicates types other than the ones mentioned above
VLAN Set the ID of the VLAN to which the MAC address belongs
Port Set the port to which the MAC address belongs
Setting the Aging Time of MAC Address Entries
Select Network > MAC from the navigation tree, and then select the Setup tab to enter the page for
setting the MAC address entry aging time, as shown in
Figure 1-4.
Figure 1-4 Set the aging time for MAC address entries
The following table shows the detailed configuration of setting the MAC address entry aging time.
Table 1-2 Configuration items of setting the aging time for a MAC address entry
Item Description
No-aging Specifies that the MAC address entry never ages out.
Aging time Sets the aging time for the MAC address entry