3Com Baseline 2928 PWR Plus - Configuring ARP Detection

2-4
Configuring ARP Detection
If both the ARP detection based on specified objects and the ARP detection based on static IP-to-MAC
bindings/DHCP snooping entries/802.1X security entries are enabled, the former one applies first, and
then the latter applies.
Select Network > ARP Anti-Attack from the navigation tree to enter the default ARP Detection page
shown in
Figure 2-2.
Figure 2-2 ARP Detection configuration page
Table 2-1 describes the ARP Detection configuration items.
Table 2-1 ARP Detection configuration items
Item Description
VLAN Settings
Select VLANs on which ARP detection is to be enabled.
To add VLANs to the Enabled VLAN list box, select one or multiple VLANs from
the Disabled VLAN list box and click the << button.
To remove VLANs from the Enabled VLAN list box, select one or multiple VLANs
from the list box and click the >> button.