3Com Baseline 2928 PWR Plus - Page 447

1-3
Figure 1-4 Configure an ACL rule to permit Host B
Make the following configurations on the page:
z Select 2001 from the Select Access Control List (ACL) drop-down list.
z Select Permit from the Operation drop-down list.
z Select the Source IP Address check box and then type 10.1.1.3.
z Type 0.0.0.0 in the Source Wildcard text box.
z Click Add.
# Configure authorized IP.
z Select Security > Authorized IP from the navigation tree and then click the Setup tab to enter the
authorized IP configuration page shown in
Figure 1-5.